.BuildingSystems.Technologies.DistrictHeatingNetworks.EnergyTransferStations.Station_dp

Information

The station model uses the ambient air temperature to determine the set point for the supply temperature in the building (secondary loop). The exact temperature depends on the parameters Tsupply_max, Tsupply_min,factor_Tsupply of the tanhAmbience block.

This set temperature is used to determine the mass flow rate in the pump pumpDHN.

The building/zone tempearture input signal is used to determine the percentage of nominal mass flow rate that should be pumped by pumpHeating. The block externalIdealHeater extracts energy so that the fluid undergoes a temperature drop equal to the paremeter Tdrop.