modelWTGTb
Extends from Dynawo.Electrical.Controls.WECC.Mechanical.BaseClasses.BaseWTGT (Drive Train Control Base Model), Dynawo.Electrical.Controls.WECC.Parameters.Mechanical.ParamsWTGTb.
Information
This block contains the updated drive train model for generic WECC WTG type 4 model according to (in case page cannot be found, copy link in browser):
https://www.wecc.org/Administrative/Memo%20RES%20Modeling%20Updates-%20Pourbeik.pdf
This model is a simplified model for the purpose of emulating the behavior of torsional mode oscillations. The shaft damping coefficient (Dshaft) in the drive-train model is fitted to capture the net damping of the torsional mode seen in the post fault electrical power response. In the actual equipment, the drive train oscillations are damped through filtered signals and active damping controllers, which obviously are significantly different from the simple generic two mass drive train model used here. Therefore, the parameters (and variables) of this simple drive-train model cannot necessarily be compared with actual physical quantities directly.
In this updated version B of the drive train, the mechanical power is derived from the electrical power by filtering with first order delay.
Parameters
| Type | Name | Default | Description |
|---|---|---|---|
| Types.PerUnit | PConv0Pu (from BaseWTGT) | Initial value of mechanical power in pu (base SNom) | |
| Drive train control | |||
| Types.Time | Ht (from ParamsWTGT) | Turbine Inertia in s (typical: 5 s) | |
| Types.Time | Hg (from ParamsWTGT) | Generator Inertia in s (typical: 1 s) | |
| Types.PerUnit | Dshaft (from ParamsWTGT) | Damping coefficient in pu (typical: 1.5 pu, base SNom, omegaNom) | |
| Types.PerUnit | Kshaft (from ParamsWTGT) | Spring constant in pu (typical: 200 pu, base SNom, omegaNom) | |
| Types.Time | tpWTGTb (from ParamsWTGTb) | Lag time constant in WTGTb in s | |
| Initialization | |||
| Types.AngularVelocityPu | omegaRefWTGQ0Pu (from ParamsWTGT) | Start value of reference angular frequency of torque control in pu (base omegaNom) | |
Connectors
| Type | Name | Default | Description |
|---|---|---|---|
| Modelica.Blocks.Interfaces.RealInput | PePu (from BaseWTGT) | Electrical active power in pu (base SNom) | |
| Modelica.Blocks.Interfaces.RealOutput | omegaTPu (from BaseWTGT) | Turbine frequency in pu (base omegaNom) | |
| Modelica.Blocks.Interfaces.RealOutput | dTorqueY (from BaseWTGT) | Torque derivative in pu/s (base SNom, omegaNom) | |
| Modelica.Blocks.Interfaces.RealOutput | dampingY (from BaseWTGT) | Damping value in pu (base SNom, omegaNom) | |
| Modelica.Blocks.Interfaces.RealOutput | omegaGPu (from BaseWTGT) | Generator frequency used for electrical control in pu (base omegaNom) |